Any product needs to know the correct maintenance knowledge, ceramic sheet is no exception, the board is a relatively long life of the green decorative material, used for floor laying and wall paste, replacement generally takes ten years, so the maintenance work is very important, the following ceramic sheet manufacturers talk about the regular maintenance of ceramic sheet.

1. Often clean the surface of the paper. When sweeping and mopping the floor at ordinary times, we must control the strength and do not exert too much force to cause long-term wear of the sheet.

1, daily cleaning: daily cleaning can choose dishwashing detergent and soap, mixed with a little ammonia and turpentine to clean.

2, stain treatment: for stubborn stains, usually acid and base detergent can be effectively removed, but the acid and base components may cause corrosion to the sheet, so the use of neutral pH detergent, in addition, encounter special stains, to learn to deal with in time according to the nature of the stain.

Two, the treatment of the gap

People who have had cleaning experience know that bacteria are more likely to accumulate in the cracks, so pay special attention to maintenance.

1. Prevention: The cracks of general thin plates are treated with caulking or sealant, which is easy to maintain and can prevent dirt from penetrating into them. But in daily life, it is necessary to scrub and clean regularly to keep the cracks beautiful.

2, treatment: the gap stains and bacteria can be smeared to stain.

3. Worn patches are used for a long time, and there will inevitably be some unevenness. The repair of thin plate wear can start from the following points:

(1) Slight scratches: You can apply toothpaste to the scratches, and then wipe with a dry cloth.

(2) The edge or center of the plate wear is small: the fallen part can paste white latex paint.

How to install ceramic sheet

Because ceramic thin plate is much thinner than ordinary ceramic thin plate, the production technology is more mature, and the construction technology is quite exquisite, the industry reminds the construction personnel, the installation of ceramic thin plate should pay attention to the maintenance before, during and after construction, the industry suggests that consumers should make the base smooth, firm and clean before laying ceramic thin plate. There can be no cracks, empty drums, sand, hemp, oil, dirt and other defects, before caulking should remove the debris between the gaps, and wet the gaps with water, and the construction environment temperature should be in 25 ~ 35. Too cold or too hot is not good.

Secondly, during the construction process, if cement based adhesive is used to stick ceramic sheet, tooth trooper should be used to comb the glue evenly, tooth shape should be full and clear, the thickness of the glue should be in 1.0 ~ 1.5 mm, with the help of the wooden bar and rubber samarium, can make the ceramic sheet and adhesive bond more firmly, the excess glue should be removed immediately.